Plastidip Matte Yellow Eraser (429ml)

PLASTI DIP liquid paint can, in matte yellow. Contains 429ml of paint (USA size).

This paint is used to coat objects and protect them from inclement weather (water), UV rays, etc. Once dry, it remains flexible and completely odorless.

It's waterproof.

Once dry, PLASTI DIP paints can be removed by simply peeling them off, like a thin adhesive film. There's no need to sand the piece or use any type of solvent for the removal.

PLASTI DIP liquid rubber forms a protective, rubbery layer, ideal for sealing, cushioning, and framing. It is also used as an anti-slip product. Especially recommended for indoor and outdoor use, it withstands extreme temperatures from -34°C to 93°C. It is also resistant to acids, alkalis, salts, oils, and numerous chemical agents.

It does not contain silicone and once dry, it can be easily removed.
Especially adherent to metals, wood, plastics, glass, fabrics, wool, stone, fiberglass or carbon fibers, etc. To increase its adhesion, you can use the primer product specially designed for Plasti Dip liquid rubber.

Instructions for use:

The surface to be protected must be dry, clean, and free of any substances that may hinder adhesion. Before opening the container and applying the product, shake gently and open. Let it rest for a few minutes to avoid air bubbles.

We can apply PLASTI DIP paint using a brush, we can also spray it, and we can also work by immersion by submerging the piece inside the paint can.
To spray it, we need to dilute the paint using PLASTI DIP solvent.

To achieve a good finish when spray painting, we need to paint by applying thin layers (4 to 6 layers on average), leaving a minimum drying time between each layer, of about 6-10 minutes.

In this case of spraying, we recommend the use of electric spray guns (also called turbine spray guns).
PLASTI DIP paint technical information:

- Stable at temperatures between -34°C and 93°C.
- Optimal application temperature, around 20°C.
- Minimum drying time on contact: approx. 5 min.
- Complete drying time: 1 hour, depending on the thickness and number of layers applied.
- The manufacturer recommends layers of 0.2mm thickness, which will require 150gr of product per m2.

Download the safety data sheet